Taxi Fairway Driver

* Interior Layout

* Aménagement intérieur

ROOF CONSOLE

The roof console houses an interior light, a digital clock and a taximeter (if fitted).

CLOCK
The time display is visible only when the ignition switch is at 'II'.
To reset the clock, adjust the hour and minute display by using a pencil or ballpoint pen to press the controls as follows:
HOURS: Press the 'H' button until the display is correct.
MINUTES: Press the 'M' button until the display is correct.
To zero the display press the 'H' and 'M' buttons simultaneously.

TAXIMETER
When fitted, the taximeter controls the lighting of the taxi sign.
The (factory set) 'Power-up' PIN number must be entered to activate the taximeter every time the battery has been disconnected.

See: Cygnus Taximeter Manual to set the taximeter.

MIRRORS

INTERIOR MIRROR (top picture)
The mirror stem with anti-dazzle head is designed to break away from the bracket on impact. The stem may be fitted in the mounting bracket as follows: align the stem (A) with the bracket ensuring the spring loaded clip (B) seats at the top of the vertical slot. Push upwards, then forward, when there is sufficient clearance to engage the lower protrusion.

Anti-dazzle
To reduce mirror dazzle, press the lever (D) towards the windscreen.

DOOR MIRRORS (bottom picture)
Electrical adjustment The control for the positioning of the door mounted driving mirrors is situated at the top of the roof mounted console (A).
To adjust either LH or RH mirror, first set the center selector switch to the appropriate side to display either 'L' for LHS or 'R' for RHS.
Rocking the top or bottom of the switch (white arrows) will result in tilting the mirror either up or down within the vertical plane.
Rocking the LH or RH side of the switch will move the mirror towards or away from the side of the cab.
When the desired position is reached, reset the center selector to the central neutral position i.e. both 'R' and 'L' visible.

LIGHTS

PASSENGER COMPARTMENT COURTESY LIGHTS (top picture)
On opening a rear door, a lamp will light automatically at floor level (A) on the same side as the door being opened.

PASSENGER'S COMPARTMENT LAMPS (bottom picture)
This push button (B) can be used to switch the passengers compartment lamps on or off irrespective of the position of the on/off control position for these lamps on the driver's fascia panel (18).
On opening a rear door, a lower wattage lamp lights automatically on the same side as the door being opened.

CONSOLE DE TOIT

La console de toit loge la lumière intérieure, la montre digitale et un logement pour le taximètre.

MONTRE
L'affichage de l'heure n'est visible que lorsque le contact est mis, en position 'II'.
Pour régler la montre, employez un crayon ou un stylo à bille pour appuyer sur les boutons de commande :
HEURES : Appuyez sur le bouton 'H' jusqu'à ce que la montre affiche l'heure voulue.
MINUTES: Appuyez sur le bouton 'M' jusqu'à ce que la montre affiche les minutes voulues.
Pour remettre la montre à zéro, appuyez sur les boutons 'H' et 'M' simultanément.

TAXIMETRE
Lorsqu'il est monté, le taximètre contrôle l'illumination du signal taxi.
Il faut entrer le numéro PIN 'Power-up' (réglé en usine) pour mettre en marche le taximètre chaque fois que la batterie a été déconnectée.

Voyez : Cygnus Taximeter Manual pour régler le taximètre.

RETROVISEURS

RETROVISEUR INTERIEUR (image du haut)
Le pied du mirroir avec sa position anti-reflet est conçu pour pouvoir se détacher de son embase en cas d'impact. Le pied doit être monté dans le support de montage comme suit : alignez la tige (A) en s'assurant que le clip à ressort (B) se loge au sommet de la fente verticale. Poussez vers le haut, puis vers l'avant, quand il y a un dégagement suffisant pour engager l'excroissance.

Anti-reflet
Afin de réduire l'éblouissement, appuyez le levier (D) vers le pare-brise.

RETROVISEURS DE PORTES (image du bas)
Réglage électrique Le contrôle d'ajustement des rétroviseurs de portes est situé en haut de la console de toit (A).
Pour ajuster le rétroviseur gauche ou droit, positionnez d'abord le sélecteur central du côté approprié, 'L' pour le gauche ou 'R' pour le droit.
En basculant le haut ou le bas de l'interrupteur (flèches blanches) on inclinera le rétroviseur vers le haut ou vers le bas dans le plan vertical.
En basculant le côté LH ou RH de l'interrupteur on rapprochera ou éloignera le rétroviseur du côté du taxi.
Quand la position désirée est atteinte, replacez le sélecteur central en position neutre, de façon que 'R' et 'L' soient tous les deux visibles.

LUMIERES

LUMIERE DE COURTOISIE COMPARTIMENT PASSAGERS (image du haut)
Lors de l'ouverture d'une porte arrière, une lampe s'allumera automatiquement au niveau du plancher (A) du côté où la porte est ouverte.

LUMIERE COMPARTIMENT PASSAGERS (image du bas)
Ce bouton poussoir (B) peut être utilisé pour allumer ou éteindre le plafonnier du compartiment passagers indépendamment de la position du bouton de contrôle situé sur le tableau de bord du conducteur (18).
Lors de l'ouverture d'une porte arrière, l'intensité de la lampe correspondant au côté de cette porte diminue automatiquement.